Piston kit w/rings B18 Race/0.5higher
Article no: 275199
Not in stock
Item not in stock, sent usually within appr. 7-14 business days.
9450 kr
- Information
-
Item GBD334400SC is well suited for honing. See more info below.CP Pistons Cylinder Honing Recommendation (for CPN & CPN2)For use with CP's CPN and CPN2 piston rings, we recommend plateauhoning with a cylinder bore cross hatch angle of 35-40°.To reach this roughness, the manufacturers of honing machines and accessoriesrecommend using for a gray cast iron engine block, and Nikasil cylinders:- Conventional stones #220 - #280 grit or- Diamond stones # 325 - #550 gritAfter honing, with either conventional or diamond stone, the samemanufacturers suggest to finish your honing by smoothing the surfacewith a fine grit conventional abraisive (#400 - #600 grit) or to sweep thebores with a flexible brush or a nylon bristle plateau honing tool. This is necessary to get rid of jagged peaks and folded or torn material.IMPORTANT NOTE:Be sure to confirm with your honing equiment manufacturer that the recommendedstone grit will produce the following Rz and Ra roughness recommendations:Rz = 59 - 138 µ in (=1.5 - 3.5 µm) orRa = 15 - 35 µ in (=0.4 - 0.9 µ m)Recommendations for installation. Further recommendations. Unit: Set - Related products
- Possible alternatives
- Set contains